Abstract

The influence of processing parameters and laser source type on cutting edge quality of AZ31 magnesium alloy sheets and differences in cutting efficiency between fiber and CO2 lasers were studied. A first part of the cutting experiments compared a fiber and CO2 laser source when cutting 1mm thick sheets in continuous wave mode and using Argon as an assist gas. The effects of cutting speed and assist gas pressure were investigated and optimal conditions were identified. In the second part of the experimental investigation, 3.3mm thick sheets were cut using fiber laser. Focal position and cutting speed were varied in order to detect the optimal combination of processing parameters to obtain the best edge quality. For both sheet thicknesses investigated, surface roughness, dross height, and striation pattern inclination were measured. Cutting quality assessment and classification was carried out according to UNI EN ISO9013 standard. Results showed that productivity, process efficiency and cutting edges quality obtained using fiber lasers outperform CO2 laser performances and therefore are considered suitable for application like sheet metal trimming.

Autore Pugliese

• Tricarico Luigi

Tutti gli autori

• L.D. SCINTILLA , TRICARICO L

Titolo volume/Rivista

OPTICS AND LASER TECHNOLOGY

Anno di pubblicazione

2013

ISSN

0030-3992

ISBN

Non Disponibile

Numero di citazioni Wos

Nessuna citazione

Ultimo Aggiornamento Citazioni

Non Disponibile

Numero di citazioni Scopus

Non Disponibile

Ultimo Aggiornamento Citazioni

Non Disponibile

Settori ERC

Non Disponibile

Codici ASJC

Non Disponibile